|
|
Build Your Online Product Catalogs?
| Product Name: |
Off Gas Preheating Continuous Feeding Equipment
|
| Supply Ability: |
1 |
| Related proudcts |
feeding equipment, |
| Specifications |
Feeding Equipment |
| Price Term: |
FOB |
| Port of loading: |
Tianjin |
| Minimum Order |
1 |
| Unit Price: |
1 |
|
AE series preheating continuous feeding equipment is the most advanced, clean, energy saving and environmental protection metallurgy off gas using equipment in nowadays. This is using the off gas from the electric furnace to preheat the raw materials, and avoided the high failure rate, complicated operation, can not charging materials continuously and other weakness from Shaft furnace preheating and preheating bucket and other traditional ways. This system has been put into production in more than 20 factories in China and several other countries. And had gain marked affects in electricity saving, energy saving, production increasing, pollution reduction, and brought great economic benefits for customers.
AE series preheating continuous feeding equipment has characteristics of continuous feeding, continuous melting, continuous smelting and others, which advantages are: smelting period is short, low power consumption, low noises, low investment cost and etc�
Co***ring with the traditional EAF, the technical index of continuously preheating and feeding EAF process are:
1. Production capacity increases more than 10%.
2. Smelting cycle is shortened by 10-15 Min.
3. Save energy of 100-120kw.h/t for per ton Steel.
4. Electrode consumption decreases by 0.5-0.8%, Refractory material consumption reduces by 5%.
5. 20-30% reduction of CO2 volume which is released from per ton of Steel; Production site dustiness is less than 10mg/M3.
6. Dioxin and CO emissions meets relative emission standards, Flue gas and dust are decreased from 17kg/t to 11kg/t.
7. Fully utilization of waste heat: On the Conveyor section can preheat the materials up to 300 degree Celsius and higher, and add burner in conveyor section that can raise the materials up to 600 degree Celsius. The rear part of the waste heat can be used to generate electricity or heating by steam which is produced by waste heat boiler, the gas from the boiler basically can go into the bag type dust collector directly. But the traditional electric furnace system of |
| Company: |
Xi’an Abundance Electric Technology Co., Ltd
|
| Contact: |
Ms. Fona Du |
| Address: |
Tangyan road |
| Postcode: |
710065 |
| Tel: |
862989388771 |
| Fax: |
862989383697 |
| E-mail: |
|
|
|
|
Home
